Pygtk progress bar not updating half life dating problems

posted by | Leave a comment

Here is a probably incomplete list of things I did to fix those problems: s, and I need to do some more testing to find any remaining bugs. So in conclusion, the new bindings for GTK 3 are less Pythonic than Py GTK was, they're more glitchy, and there's less documentation. That's not really a useful conclusion, as I'm just repeating conventional wisdom, which turned out to be correct in this case. In 2012, it would probably have been more efficient to put this time towards porting my software to a web app.

The preferred place to ellipsize the string, if the progressbar does not have enough room to display the entire string, specified as one of the Pango Ellipsize Mode Constants.

im kinda hoping you have solved that prob, the only solution i came up with is have both a int and float for same health variable(and such) then synchronize them constantly which sounds like it should be unnecessary work nvrm i figured it out, dum mistake i overlooked. However after a blueprint re-compile this is sometimes resolved sometimes not. If you are still experiencing the issue you reported, please respond to this message with additional information and we will offer further assistance. This is because the progress bar percentage can only be 1 and will not allow another figure.

This code prints “Hello” into the terminal when the button is clicked so immediately after you click the button you can click it again and it works.read a fixed number of bytes from a file) and can monitor its progress, it can use the () method nudges the progressbar to indicate that some progress has been made, but you don't know how much.This method also changes progress bar mode to "activity mode," where a block bounces back and forth.Without this the GTK main thread would continue running while no interface would be displayed. Just change the code to look like the following: Now execute it. When you click the button, it goes down like it was pressed, but does not come backup.We want the application to exit when the window is closed, so we tell the GTK loop to stop so we can quit. You should get an application similar looking to this: Clicking the button prints “Hello” in the terminal and the interface is still usable. Maybe we wanted to…wait 20 seconds and THEN print “Hello”? The GUI stopped drawing as soon as the button was clicked.

Leave a Reply

meddlers dating